Intonaco Veneziano Tadelakt Traditional Moroccan Wall Finish (4 Gallon 16kg)

Description

Mix a 16 kg. container material with about 1 and 1/2 gallons of water. Once the material is well-mixed, it can be colored and then left to rest for about a half an hour. It can then be applied, either that day or the next. (The material will still be good for several days if it is kept in a sealed container away from heat. However, it's best to apply it within 2 or 3 days.) -After the substrate has been prepared, the first coat, tinted or not (white), is applied with a metal trowel. (With the traditional Moroccan method, it is applied with a tool similar to a Swiss trowel which leaves a slightly wavy surface.) Let the first coat dry completely (overnight). Remember that part of the pattern that is left in the first coat will be visible in the finished work. -Before beginning the second coat, we advise, as we do in the instructions for Marmorino Carrara, to replace all the protective tape. For the second coat, apply the material with the color of your preference with a large, metal trowel. As with Marmorino Carrara, it should be applied over the entire surface smoothing out any marks left by the trowel, keeping in mind that any marks left at this stage with remain visible in the final surface. (For those wishing for a completely smooth surface, pass over the entire surface with a with a sponge float.) Let it dry a little until it loses its shine, which is due to an excess of water. In some places you will see a slight lightening of the color. -At this point you can apply the third coat using the same material and the same big trowel, or a smaller one if you chose. The important thing is to use a trowel with sharp edges. Apply a thin layer, pressing (unifying) the second and the third coat into one thickness. You will have to pass over the surface numerous times, always moving the trowel in different directions until you achieved the desired finish. If you see bubbles appear during this stage, you'll need to wait a little more before the final burnishing stage.