.com The DELTA 28-165 Bench Band Saw Blade is a replacement blade for the DELTA 28-180 and 28-185 Bench Band Saws, as well as other saws that require a 56-1/8-inch blade. You'll make fast and accurate cuts thanks to high-carbon-steel construction that stays sharp, and teeth that were precision machined. The blade is 1/4-inch wide with 6 teeth per inch, cuts down to a 3/4-inch-inch radius, and has been tension-tested for strength. From the Manufacturer Delta 28-165 Bench Band Saw Blade 56-1/8-Inch x 1/4-Inch, 6 Teeth per Inch
M**1
Replacement blade for band saw
The blade was an exact replacement for the band saw. Took a while to fit it to the band saw as there are several adjustments necessary that insure the blade has adequate pulley pressure so the blade does not slip and proper alignment to insure the blade stays withing the guides. Actually a good learning experience as I found the factory installed blade was not within the guides and subject to moving while being used. The new blade is installed correctly and stays on line when cutting.
M**I
Perfect
Found an old 3 wheel delta band saw long ago, it’s great, blade broke, couldn’t find this size anywhere! Found it here, awesome!!!! 🙏🏼🙏🏼🙏🏼
A**R
Great tool - great price!
Great product & once the correct tension is set it’s been cutting like butter. Does exactly what I needed it to do.
K**T
Very sharp
I had thought my old blade was sharp but that I must have been doing something wrong. I was trying to rip a red oak 1x2 on edge on a 30 degree bevel (for a threshold / door stop) and the wood kept closing in on the blade, jamming the saw. Not only that, but the cut had drifted 1/16 inch. Since I was only 1/6 through that was looking like a big problem. Interrupting that work I tried cutting a small piece of cedar and the old blade broke.I found this new one - reasonable price and ordered. Installation was no problem and I applied a little solid lube to it so it would coat the blade guides, which I reset close to the blade and close to the deck. I set up the saw again for ripping the oak threshold, paying more attention to its drag on its wood scrap guides clamped to the deck. With trepidation I started the saw and started feeding the wood. It cut like butter, straight and clean. That's sharp.
D**Y
Toothy critter.
I was able to mount the blade easily and no lubercation needed. It was a tight fit, which, is always a nice change from looose, sloppy blades.No need for a call the next day.
D**J
Fine
It's fine, just the wrong size......so not really a valid assessment.
J**S
Five Stars
It's great hubby says.
L**T
Size not as advertised.
Blade measurement was 1" short. Did not fit!
Trustpilot
2 weeks ago
4 days ago