Easy-Peelzy XL, the easy removal 3D printing platform for large format printers with PLA and PLA-based materials. You can cut it into any smaller size or shapes to fit your printer! Size is 30 x 30 cm square, or approximately 12 x 12 inches. To use it, simply stick the bottom plate onto your build plate and start printing, peel up the top plate with finished prints, then peel off the top plate from the prints. Snap the top plate back into place for next round of printing. Warning: Do not expose Easy-Peelzy XL to heat over 80 °C or 176 °F, or your Easy-Peelzy XL risk demagnetizing! Due to the magnetic nature of Easy-Peelzy, magnetic printer bed leveling sensors might not work with it.
L**L
Worked great, until....
This worked great for PLA. I was using it for a lot of work.I did have some de-bonding of the upper surface from the magnetic surface, but that was minor.Most printers put out a skirt. This was difficult to remove. If I tried to be aggressive, it would scratch the print surface. If I printed on top of the remaining skirt, I wound up with different colors on the bottom.Finally, I needed to print some PETG. This uses a temperature of 80C on the bed. Since the magnetic bed adheres to the bed, I was unable to take it off. The temperature essentially melted the magnetic bed. Too bad. It was working pretty good.
A**N
Prints sometimes fuse to build surface
Best thing I've bought for my printer, just make sure your nozzle isn't too low. But for the price point a replacement is very justifiable.
K**N
Failed quickly
Thought I had finally found the perfect print surface, but no. The center of the surface cracked and separated after less than a week of printing. Maybe I got a bad one, I'll try to get a replacement and keep this review updatedUpdate:I received my replacement and have used it for about two weeks, and it is failing once again, in a few ways at once. The adhesive that sticks the magnetic sheet to the build sheet is failing so although the magnets still work fine, the sheet will peel up during printing. It is also cracked in at least three places along the edge.This product seems cheap for what it offers, but the math doesn't work if you have to replace it twice a month..
L**O
Cutting required
Had to cut to fit
D**N
BEST UPGRADE EVER!!!!!
Only one word describes these. AMAZING!!!!!!! THIS IS LITERALLY THE BEST THING EVER FOR ANY PRINTER!!!!!!! I've printed many these with it and it works flawless still!!! I will be ordering one for every single one of my printers and using these for my big printer I'm currently building now
M**N
It works but it doesn't
The first few prints to come off this were spectacular. However, the top sheet is very fragile - if you bend it too far (to remove a print), you'll likely crack the surface.
B**N
New Ender has removable surface
I jumped the gun on this purchase. The new Ender 3's have a removable fiberglass based bed. It works great and is flexible. No need for this magnetic sheet stuff, IMO. But it has great reviews, otherwise.
J**S
Cant get brim/skirt remnants off..
Sticks too well...
Trustpilot
3 weeks ago
3 days ago